speedway
09-21-2003, 07:49 PM
I have an older CEN MT1 that was having trouble running, as it warmed up it would quit. Everyone said the engine was worn out so I replaced the piston and cylnder. It deffinatly runs better and was easier to tune but still will seem to be running just fine and just quits. Any ideas or help would be greatly appreciated!!!!
MOCKBA
01-20-2004, 04:35 PM
Make sure you are not overheating it, cause that usually happens from overheat. Read in the manual about the good and a max temp that engine should have and use an infrared temp proble to measure your engines temp.
Hope that helps
dude7422
10-11-2006, 11:02 AM
You Dont Need A Temp Gun Just Drip Spit On The Top Of Head And If It Tops Off The Motor Is Too Hot Richen Up The Fuel Mixture Pt2 If The Spit Sets And Boils It Not The Temp What Ya Think People Did Before Temp Guns Dee Dee Dee Lol Hope This Helps Dude