SaleTradeorBuy
06-21-2005, 12:21 AM
Hi, I have a Traxxas TRX PRO.15 nitro engine for sale. This engine came off of my old T-maxx, but it will also fit the Nitro Hawk, Buggy, Sport, Street, Stampede and Rustler. You can use the header and carb to turn a regular TRX-15 engine into the better performing TRX PRO .15 engine. This engine does not run! The compression was very low, so I took this engine apart piece by piece. Here is the list of parts needed if you would want to rebuild. All the prices are retail.
1.)Piston and sleeve part# 4030 ($40).
2.)Crankshaft Bearings part# 4023 ($16 for 2)
3.)Crankshaft - The one bearing inner race is seized to the crankshaft, so you may have to get another crankshaft too unless you can pry the race off. part# 4019, 4020, 4021 depending on application ($20, $18 or $18).
As for the good parts. All these parts where completely cleaned, are in good condition and are ready for rebuild. The prices are not what I'm asking for, they are retail prices, just to show how much they cost separately.
1.)Crankcase part# 4022 ($30)
2.)Pro Cooling Head - the header is scratched on top, but otherwise in fine condition part# 4032 ($40)
3.)Backplate part# 4074 ($10)
4.)Backplate gasket - is in good condition, but is suggested by Traxxas manual it should be replaced part# 4013 ($1.25)
5.)Flywheel part# 4124 ($7.50)
6.)Starter shaft part# 4077 ($7.50)
7.)Clutch adapter nut part# 4144 ($5.25)
8.)Split bevel cone part# 3281 ($3)
9.)Motor mount part# 4960 ($11)
10.)Clutch shoes - good condition, but is missing metal spring part# 4146 ($7.25)
11.)5x8mm ball bearings (2) part# 2728 ($8)
12.)Clutch bell 20 tooth ($12)
13.)Misc. screws and washers
I also took the Carburetor apart piece by piece, cleaned it, and rebuild it. Everything in the carb is in very good condition.
14.)Pro Carb part# 4033 ($40)
Best Offer for everything. The engine is stripped down to every piece, but will rebuild it with the worn parts if necessary. You can see pics here:
http://groups.msn.com/myownvariouspics/shoebox.msnw?Page=2
I will also will be selling the tranny, gas tank, fuel hoses, fuel filter, exhaust header and muffler for the old version T-maxx on a separate thread.
Thanks
Email Me if interested
Mcraig2001@msn.com
1.)Piston and sleeve part# 4030 ($40).
2.)Crankshaft Bearings part# 4023 ($16 for 2)
3.)Crankshaft - The one bearing inner race is seized to the crankshaft, so you may have to get another crankshaft too unless you can pry the race off. part# 4019, 4020, 4021 depending on application ($20, $18 or $18).
As for the good parts. All these parts where completely cleaned, are in good condition and are ready for rebuild. The prices are not what I'm asking for, they are retail prices, just to show how much they cost separately.
1.)Crankcase part# 4022 ($30)
2.)Pro Cooling Head - the header is scratched on top, but otherwise in fine condition part# 4032 ($40)
3.)Backplate part# 4074 ($10)
4.)Backplate gasket - is in good condition, but is suggested by Traxxas manual it should be replaced part# 4013 ($1.25)
5.)Flywheel part# 4124 ($7.50)
6.)Starter shaft part# 4077 ($7.50)
7.)Clutch adapter nut part# 4144 ($5.25)
8.)Split bevel cone part# 3281 ($3)
9.)Motor mount part# 4960 ($11)
10.)Clutch shoes - good condition, but is missing metal spring part# 4146 ($7.25)
11.)5x8mm ball bearings (2) part# 2728 ($8)
12.)Clutch bell 20 tooth ($12)
13.)Misc. screws and washers
I also took the Carburetor apart piece by piece, cleaned it, and rebuild it. Everything in the carb is in very good condition.
14.)Pro Carb part# 4033 ($40)
Best Offer for everything. The engine is stripped down to every piece, but will rebuild it with the worn parts if necessary. You can see pics here:
http://groups.msn.com/myownvariouspics/shoebox.msnw?Page=2
I will also will be selling the tranny, gas tank, fuel hoses, fuel filter, exhaust header and muffler for the old version T-maxx on a separate thread.
Thanks
Email Me if interested
Mcraig2001@msn.com